12/8/2023 0 Comments Convert 12f auto connector to 110vBut be careful! The wires can get very hot and burn you. If you want to keep a light or appliance from coming apart, you should solder the wires together and cover them with electrical tape. This is often the preferred method if someone wants their light or machine to disconnect without cutting into it. The screw-on wire nuts allow you to make sure that they do not become loose too quickly, protecting people and appliances from exposed wiring. If you want your light/appliance to be able to unplug from your extension cord at any time, place each wire nut over each twisted section and tighten them down securely. You now have two options for completing this second end of the cord: Remember, there are three wires in this cord, so you will need to twist together each wire with its neighbors. If any strand is longer than another, wrap it around the shorter piece(s) first. ![]() To make a clockwise loop with the three strands of insulated wire from an extension cord, twist them together. Then, you need to strip 1 foot of insulation off of both ends of the extension cord, exposing at least 3/4 inch of bare wire on each end. In order to work with the wires, you need to take them out of the two-wire nuts and lay them out. This makes it easier to attach wires without stripping them individually and ensures enough room for all three conductors in your cord. You will strip away about 1′ of insulation from this free end that you just made into a cord. The female plug should remain intact on one end, while the male plug will get cut off even with the outer insulation on the other end. ![]() To make an extra long 4′ extension cord, you will need to cut the male end off of an extension cord.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |